Jump to content
Computer Audiophile

Search the Community

Showing results for tags 'pure vinyl'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Categories

  • Reviews
  • CA Academy
  • Audio Shows
  • Bits and Bytes
  • Digital Vinyl
  • The Music In Me

Blogs

There are no results to display.

There are no results to display.

Categories

  • Downloads
  • CA Sample Club's Files

Forums

  • Equipment
    • General Forum
    • Music Servers
    • DAC - Digital to Analog Conversion
    • Disk Storage / Music Library Storage
    • Networking, Networked Audio, and Streaming
    • Headphones & Speakers
    • Software
    • DSP, Room Correction, and Multi Channel Audio
    • iTunes and Everything Apple
    • Article Comments
  • Music
    • Music Downloads & Streaming
    • Music in General
    • Music Analysis - Objective & Subjective
    • In Memoriam
  • Sponsored Forums
    • Sonore (Sponsored)
    • HDtracks (Sponsored)
    • UpTone Audio (Sponsored)
    • Highend-AudioPC (Sponsored)
    • Abbingdon Music Research / iFi audio (Sponsored)
    • Ciamara (Sponsored)
    • Vinnie Rossi (Sponsored)
    • Klipsch (Sponsored)
  • CA All Access
    • Buy & Sell Audio and Computer Components
  • Allo's Allo Topics
  • CA Sample Club's Topics
  • CA Sample Club's Q & A

Found 1 result

  1. Hi there, This is Todd from AudioFlea. I'm about to get going on a project to rip all of my vinyl to digital! The idea is that I want to take my music with me when I travel (for playback with Shure SE846 headphones), use in my car with my McIntosh and Dynaudio based system, or listen to when I'm in the office. I understand that the folks over at Channel D strongly recommend using their own software-based RIAA correction, but I'm wondering if anyhere here has any anecdotal experience in comparing the Pure Vinyl RIAA with a good high-end, analog phono stage. In my case, I would be using the ASR Mini Basis Exclusive as a phono stage. My cartridge is the Rega Apheta which is a low output moving coil, so I will need to figure out my gain stage to put between the table and the software. For anyone who has walked this path before, how did you end up using your low output, moving-coil cartridge with the software based RIAA correction in Pure Vinyl?
×