Jump to content
Computer Audiophile

Search the Community

Showing results for tags 'dynaudio xeo 3'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Categories

  • Reviews
  • CA Academy
  • Audio Shows
  • Bits and Bytes
  • Digital Vinyl
  • The Music In Me

Blogs

There are no results to display.

There are no results to display.

Categories

  • Downloads
  • CA Sample Club's Files

Forums

  • Equipment
    • General Forum
    • Music Servers
    • DAC - Digital to Analog Conversion
    • Disk Storage / Music Library Storage
    • Networking, Networked Audio, and Streaming
    • Headphones & Speakers
    • Software
    • DSP, Room Correction, and Multi Channel Audio
    • iTunes and Everything Apple
    • Article Comments
  • Music
    • Music Downloads & Streaming
    • Music in General
    • Music Analysis - Objective & Subjective
    • In Memoriam
  • Sponsored Forums
    • Sonore (Sponsored)
    • HDtracks (Sponsored)
    • UpTone Audio (Sponsored)
    • Highend-AudioPC (Sponsored)
    • Abbingdon Music Research / iFi audio (Sponsored)
    • Klipsch (Sponsored)
  • CA All Access
    • Buy & Sell Audio and Computer Components
  • Allo's Allo Topics
  • CA Sample Club's Topics
  • CA Sample Club's Q & A

Found 3 results

  1. Hi. I think my Midi Audio Setup settings are a bit mangled, and wanted to reset them to defaults. Deleting the midi audio prefs file, along with PRAM, safe boot, and SMC resets didn't work. Can anyone with a Xeo share their settings for both input and output screens? Thanks!
  2. I was sad to see my Audience 42s sell recently...I had them for 10 years! But they've been replaced with pair of Xeo 3s, purchased from a Dyn dealer as a demo set. He said that they haven't been played much at all, basically they're new, so they should be broken in. I imagine that the break in affects the amps and the drivers, right? On the drivers, what is a good general rule? I've heard 40 hours of low-moderate volume listening, and after that it's safer to play deep bass and louder volumes. And there is mention the the break-in process can go to about 400 hours. True? What are your experiences with your Xeo 3s?
  3. Hello all, Reading these forums I've become more and more focused on achieving a short simple (and cheap!) path from source to speaker. I'm sure I'm not the only one who has taken the route described below, and since I'm struggling I was hoping that someone who has gone the same way might be able to help: > I rip to FLAC using Db poweramp on my PC, or download a similar quality source. >> I sync files to my Samsung S4 mini (I have a 64GB min SD card) >>> I want to stream them to my Xeo 3s - which accept a digital stream via mini USB or SPDIF input. However the S4 mini doesn't appear to support USB OTG/isn't able to directly stream the files. Do you know of any app or device that will encode and stream my FLAC files from the phone mini USB to mini USB/SPDIF of the Xeo 3 transmitter so that the signal stays digital and lossless all the way to the Dynaudio speaker DACs please? I've read the primers, but can't get to grips with the language - guess I've reached my techonolgical limits - so simple solutions preferred, if possible! Any help would be greatly appreciated...
×