Jump to content
Computer Audiophile

Search the Community

Showing results for tags 'arcam rdac'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Categories

  • Reviews
  • CA Academy
  • Audio Shows
  • Bits and Bytes
  • Digital Vinyl
  • The Music In Me

Blogs

There are no results to display.

There are no results to display.

Categories

Forums

  • Equipment
    • General Forum
    • Music Servers
    • DAC - Digital to Analog Conversion
    • Disk Storage / Music Library Storage
    • Networking, Networked Audio, and Streaming
    • Headphones & Speakers
    • Software
    • DSP, Room Correction, and Multi Channel Audio
    • iTunes and Everything Apple
    • Article Comments
  • Music
    • Music Downloads & Streaming
    • Music in General
    • Music Analysis - Objective & Subjective
    • In Memoriam
  • Sponsored Forums
    • Sonore (Sponsored)
    • HDtracks (Sponsored)
    • UpTone Audio (Sponsored)
    • Highend-AudioPC (Sponsored)
    • Abbingdon Music Research / iFi audio (Sponsored)
    • Ciamara (Sponsored)
    • Vinnie Rossi (Sponsored)
    • Klipsch (Sponsored)
  • CA All Access
    • Buy & Sell Audio and Computer Components

Found 1 result

  1. I have a pair of Polk OWM5 speakers connected to a Yamaha RX-V667 Receiver, which is then connected to my ARCAM rDAC, which is then connected to my new 27" iMac. 90% of the time when I try playing audio out of my iMac after the computer has been sitting idle for a while, the audio will start to play back normally for about 1-3 seconds, and then it quickly starts to get crunchy/staticy... the noise typically heard at a McDonald's drive-through window. If I switch the audio output source on my iMac to any other source (such as the internal speakers), and then immediately switch back to my DAC, it resolves the problem and I can then play audio normally for an extended amount of time. The same problem was also happening with the DAC I just upgraded from, the AudioEngine D1. I'm kind of at a loss here and I was hoping someone could help me shed some light on what the problem might be. Any suggestions would be greatly appreciated... Thanks!
×