Jump to content
Computer Audiophile
Dougal

Subwoofer Question?

Rate this topic

Recommended Posts

Dougal   

Hi guys

 

Just took a chance on a cheap (£95 GBP) subwoofer that seems to work ok on my system, which is; 

Optical data out of PC into SA-50 desk amp. Amp into sub only via ‘High Level  In’  and ‘High Level Out’  (no Line-In or Line-Out on the little Amp) and on to Q-Acoustics 3010 speakers.

 

The Q-Acoustic speaker specs state: 86dB, Rec Power: 15 - 75w, Crossover Frequency: 2.8kHz

Frequency Response (+/- 3 dB): 68Hz - 22kHz, Nominal Impedance: 6ohm, Minimum Impedance: 6ohm

 

However, the frequency adjuster on the sub shows 50-150 Hz

 

Aside from just tweaking by listening, are there any numbers that should or shouldn’t work?

 

I’m confused by the speakers stating 2800 Hz, while the sub doesn’t reach that.  Should it?

Share this post


Link to post
Share on other sites
PorkChop   

You're right, that 2800 Hz number can't be referring to SW, so it might just be refering to the internal crossover frequency between its 2 drivers. 

 

I would think you're going to want to set your sub between 100 and 120 Hz, but yes listening is the way to figure out exactly where. 

Share this post


Link to post
Share on other sites
Dougal   

I'll not make the mistake of buying cheap eBay subs again:-(  The cable connections are just those spring loaded tabs for hold speaker wires.  OK in themselves IF decent quality, but one broken already on FIRST use!  Pressed tab with one finger to push speaker wire in....  Spring disappeared down into sub internals and clip fell off!!!  Spring no doubt  just waiting near PCB to create internal mains electrical short!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×