Hello to the forum!
It's my first post and it is ... of course ... a question ;-)
At the moment I use a Raspb3, configured with moode for a Philips ps1/12 (HDMI) and feeded by an iPad with Airplay or by moode on the raspberry. Apart from some interruptions if receiving a video stream, that setup works perfect for me.
Now Iam looking for more situations, where I can use it and I have some questions for these cases:
Case 1:
I wanted to use the above configuration added with an Hifiberry DAC+Pro on a Beolab 6002 (Chinch to Din5pol-Cable). The Beolab is configured in "line". But if I switch the Beolab on, there is a hum/buzz. It is a little bit quieter, if the Hifiberry LED signed, that the board is active. I tried different power supplies and two different ground loop isolators without success. Only the pitch differs a little bit and if I play music with Airplay, it is quieter (but not away) than without music.
Has any one an idea about the problem and (more important) a solution, before I send the Hifiberry back to Amazon?
Case 2:
In the living room of a girl friend is a television (with rj45 network capability) and a surround-receiver. It is 10 m away from the internet router. The goal would be, to add Airplay to the receiver (HDMI from Raspberry) and additional Internetaccess for the television by WLan. If I don’t want to buy an extra repeater for the television, it is needed to configure the moode/rasp. as an repeater and connected per ethernet-cable to the television.
Is there a possibility configuring the rasp. in this way? And, if the only way is by terminal … is there a step by step instruction?
Thanks very much.
